Skip to main content

Passcode

Passcode Provider is designed for user authentication with a password that users set themselves, and for joint use with the Axidian Access products.

Passcode can be used for authentication in the following modules:

Provider ID
{F696F05D-5466-42b4-BF52-21BEE1CB9529}

Prerequisites​

The provider requires Bsp Broker installed on the Axidian Access server.

Files for Bsp Broker are located at Axidian Access <version number>\Axidian Providers\Axidian Bsp Broker\<Version number>.

  • AuthProviders.BspBroker-<version number>.x64.en-us.msi — the installation package of Bsp Broker for 64-bit operating systems.
  • AuthProviders.BspBroker-<version number>.x86.en-us.msi — the installation package of Bsp Broker for 32-bit operating systems.

Install the provider​

  1. Run the installation file located at Axidian Access <version number>/Axidian Providers/Axidian Passcode Provider/<version number> and follow the steps of the installation wizard.

    Important

    If several Core Servers are used in your infrastructure, install the provider on all the servers of the infrastructure.

  2. After the installation is complete, a system restart may be required. If the installation wizard prompts you to restart the system, confirm this action.

  3. To remove or restore the product, open the Control panel menu and use the standard procedure for the supported operating systems.

Additional settings

To configure the password requirements, go to the group policies section for Passcode.